2 Piece 1-1/2'' SRT paint brush with stainless steel ferrul yellow handle and easy to use trim brush for home repair
STAIN BRUSH:1 Piece 5.5 inch big stain fence brush with SRT and Nature blended bristle more paints hold 30% than another current paint brush premium ferrule in copper finish for speed work
2 Sized Paint roller assorted with superior quality for all paints 100% polyester 10mm Nap
9-inch black durable plastic paint liner and easy to clean up
KINGORIGIN Since 1878, We Manufacturer Paint Sundries Over 100 Years Great choice for all paint jobs interior and exterior use
Glide along moldings, zip around corners, paint circles around fixtures!
Paint an entire room in less than one hour
Get perfect results every time
No more paint prepping, runs or brush strokes
Love tacos? You’ll love them even more with a taco stand. Building a taco stand is quick and inexpensive and is perfect for taco night with friends and family. Here’s what you’re going to need for this project:
TOOLS & MATERIALSMiter Saw Tape Measure 3½” x 3½” x 48” Hardwood Board Sandpaper Mineral Oil Rags Fast Drying Wood Glue Pencil Nitrile Gloves
When taking on this DIY task, be sure to equip yourself with the proper safety gear.
SAFETY GEAREye Protection Ear Protection Mask
Measure and cut pieces. So you’re going to set your miter saw to 60 degrees and cut a scrap piece of wood to use as a stop for your cuts. Then you’re going to mark three inches from the edge of your board. Cut off the end at 60 degrees. Then measure and mark three inches. Clamp your stop on the miter fence, aligning it with your three inch mark. Then tighten the clamp and cut 12 pieces of wood. Flip your board and cut that remaining 90 degree angle to 60 degrees. Set your miter saw back to 0 degrees and cut that remaining piece in half. To ensure your pieces are properly aligned, lay them out on the end of a table, marking where they meet the edge. Cut your miter saw to 30 degrees and cut the end pieces so the foot rests flat on that table. After you’ve made all your cuts, lightly hand sand your pieces to smooth any rough spots.
Glue. Make sure you put on your nitrile gloves and apply a small amount of fast-drying wood glue on the end of two pieces and join them together. Then hold for 30 seconds and then proceed to the next piece. When all of your 30 degree pieces are attached, you’ll have 12 in all. Secure each end piece with glue. Next let dry for 30 minutes before you move on to this next step.
Sand. Sand the entire stand with 50 grit sandpaper. Then get a damp rag and wipe the surface of the wood to raise the grain. This will help you get a better finish. Once dry, finish sanding with 150 then 220 grit sandpaper.
Finish. Generously apply mineral oil to the entire surface of your stand. Add tacos and your project is complete. Dig in!
From Source Article: moneypit.com